Yawcam Embedded Audio (Working)
Posted: Fri Jun 26, 2020 12:04 am
Here's is another attempt to get audio working with Yawcam.
So far working but a bit of lag because the PC I have it on is very slow.
First, download and install Stream What You Hear (totally free): http://www.streamwhatyouhear.com/?source=swyh
Once installed and running
Go to settings
Stream to MP3
Format 48000 16 bit mono bitrate 128
Select audio source (your camera)
Only check use specific http port (I used 5901)
Now open Yawcam / Setting / Edit Setting / Stream / Page Designer
Enter the following:
<audio controls autoplay>
<source src="http://192.168.1.177:5901/stream/swyh.mp3" type="audio/mpeg">
<source src="http://192.168.1.177:5901/stream/swyh.mp3" type="audio/ogg">
<p><center>Audio may be delayed.</center></p>
</audio>
Replace the IP with the one from your PC
There is a delay like on other attempts to embed audio.
Also, depending on device, the audio may not autoplay.
I created this with a bit of guess work.
Any attempts to improve would be appreciated.
Any problems, I will try to help...
So far working but a bit of lag because the PC I have it on is very slow.
First, download and install Stream What You Hear (totally free): http://www.streamwhatyouhear.com/?source=swyh
Once installed and running
Go to settings
Stream to MP3
Format 48000 16 bit mono bitrate 128
Select audio source (your camera)
Only check use specific http port (I used 5901)
Now open Yawcam / Setting / Edit Setting / Stream / Page Designer
Enter the following:
<audio controls autoplay>
<source src="http://192.168.1.177:5901/stream/swyh.mp3" type="audio/mpeg">
<source src="http://192.168.1.177:5901/stream/swyh.mp3" type="audio/ogg">
<p><center>Audio may be delayed.</center></p>
</audio>
Replace the IP with the one from your PC
There is a delay like on other attempts to embed audio.
Also, depending on device, the audio may not autoplay.
I created this with a bit of guess work.
Any attempts to improve would be appreciated.
Any problems, I will try to help...