Yawcam webcam fps not persisting

[meteobreda]

Hello,

I put 4 webcam for USB HUB.
I only see two cameras, I think because 800x600 and 30fps is too for USB 2.0
If i put 640x480 and 5fps all cams work fine.
The problem is when I close Yawcam, the next time I start Yawcam the fps is 30.

Could you help me?

Best regards,

[z3r0c00l12]

You're right, your bandwidth is probably limited by the USB hub.

[meteobreda]

Ok, but...

Is possible limit fps?

[z3r0c00l12]

I believe the fps setting is only on the driver side and not part of Yawcam, so there's not much Yawcam can do to save the setting. I know under the stream there is an option to change the fps, and that should remain set after a reboot.